Structural Engineering & Statics
where the load goes
Concept

D-region — where it appears

A part of a structure where plane sections do not remain plane, near a support, a concentrated load or an abrupt change of shape. Beam theory does not apply there, so the region is designed instead with a truss of struts and ties chosen by the designer.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

Also named here as transverse tension — the same set of essays touches all of them, so they are one junction rather than several.

The force spreads, and the spreading needs a tie. The end block behind an anchorage of 1200 kN on a 200 mm plate, in a section 700 mm deep. Half the force enters at the quarter point of the plate and leaves at the quarter point of the section, so a strut between the two rises 125 mm and needs a transverse tie to turn it. Placing the tie 0.5 depths from the face makes that tie force 214 kN — and at exactly half a depth this reproduces Guyon's 0.25P(1 − a/h) to the digit, which makes that famous coefficient a lever arm somebody chose rather than a property of concrete. The bearing stress under the plate is 20.0 N/mm² against 5.7 once the force has spread.

The force that splits what it pushes on

A prestressing tendon delivers its whole force through a plate a fraction of the section deep. One depth further along the stress is uniform, and the spreading in between requires a transverse tension nobody applied — the force that splits end blocks, and the only number in the design that no equilibrium equation on the member can see.

internal-forces · Anchorage zone A truss drawn inside a solid, and solved as one. A deep member 5000 mm between bearings and 2500 mm deep, carrying 2400 kN at mid-span. The model is two struts and one tie, on a lever arm of 2000 mm, and it is solved by the truss solver rather than by a formula: the tie comes back at 1500 kN and each strut at 1921 kN, at 38.7° to the horizontal. Spread over a strut width of 1031 mm the compression is 3.7 N/mm² against a limit of 18.1 for concrete cracked across its own strut, and the tie needs 3448 mm² of steel. A beam calculation on the same member would have asked the tie for 1404 kN, which is 7% less than the model does.

The node is the part that is checked

A strut-and-tie model is safe if every part of it can carry what the model asks. The struts are wide and lightly stressed, the ties are steel and easy, and the whole of the difficulty collects at the points where they meet — in a volume of concrete a few hundred millimetres across that no drawing shows.

internal-forces · Strut-and-tie

Named alongside it

The objects these essays reach for when they reach for this one.

Bearing stressConcrete strengthEquilibriumLower-bound theoremReinforcementStrut-and-tieTransverse tensionAnchorageAnchorage zoneBondBurstingFree body

All concepts