Structural Engineering & Statics
where the load goes
Concept

Anchorage zone — where it appears

The region behind a concentrated force where the stress has not yet spread across the section, about one member depth long. It carries a transverse tension that no sectional calculation contains, and reinforcing it is the whole of designing an end block.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

Also named here as bursting, stress trajectory — the same set of essays touches all of them, so they are one junction rather than several.

The force spreads, and the spreading needs a tie. The end block behind an anchorage of 1200 kN on a 200 mm plate, in a section 700 mm deep. Half the force enters at the quarter point of the plate and leaves at the quarter point of the section, so a strut between the two rises 125 mm and needs a transverse tie to turn it. Placing the tie 0.5 depths from the face makes that tie force 214 kN — and at exactly half a depth this reproduces Guyon's 0.25P(1 − a/h) to the digit, which makes that famous coefficient a lever arm somebody chose rather than a property of concrete. The bearing stress under the plate is 20.0 N/mm² against 5.7 once the force has spread.

The force that splits what it pushes on

A prestressing tendon delivers its whole force through a plate a fraction of the section deep. One depth further along the stress is uniform, and the spreading in between requires a transverse tension nobody applied — the force that splits end blocks, and the only number in the design that no equilibrium equation on the member can see.

internal-forces · anchorage zone An enhanced strength that is the strength of a tie. Bearing strength as a multiple of the design cylinder strength, against how far the load is allowed to spread, with the bursting tension the spread creates on the same axis. The enhancement is √(A₂/A₁) and it reaches 2.80 for the 250 mm pad on a 700 mm block drawn — 47.6 N/mm² against a design strength of 17.0. There is no material property in that statement beyond the one being enhanced, and the reason is on the second curve: a load that spreads does so along inclined struts, a pair of inclined struts has a horizontal component, and that component is 16.1% of the load. It has to be tied. 1099 mm² of steel is what the enhancement actually is, and the cap of three is not a property of concrete — it is the angle past which nobody believes the strut.

Three times as strong under a smaller pad

Press a small plate onto a large block of concrete and it will carry three times the stress a cylinder of the same concrete fails at. The enhancement is a ratio of areas with no material property in it, which should be a warning: what has actually been measured is not the concrete's strength but the strength of a tie holding it together.

internal-forces · bearing stress

Named alongside it

The objects these essays reach for when they reach for this one.

Bearing stressBurstingFree bodyLower bound theoremSplittingStress trajectoryStrut and tieBearingConcrete strengthConfinementD regionDiscontinuity region

All concepts