Structural Engineering & Statics
where the load goes
Concept

Weld shrinkage — where it appears

The contraction a weld would undergo on cooling if it were free, and the force that results when it is not. The metal yields in tension while hot and stays that way when cold, so what is left is a locked-in force at about the yield stress, applied along the weld and at the weld's own position on the section.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

Steel has a third direction and it is not as good. Through-thickness strain demand against weld size, on a 30 mm plate, with the ductility the plate can supply in each of its three directions drawn across it. Rolling stretches the plate's inclusions into flat stringers, so a bar cut along the rolling direction, one cut across it and one cut THROUGH it are three different specimens of one steel — 60, 45 and 15 per cent reduction of area, which converts exactly to a true fracture strain of ln(1/(1 − Z)): 0.916, 0.598 and 0.163. A factor of four in the reported percentage is 5.6 in the strain the material can take. The demand goes as the deposited area over the square of the thickness, so doubling the weld size quadruples it: the 12 mm throat drawn asks for 5.4 per cent, which an ordinary plate supplies and a plate with a bad inclusion cluster does not.

The direction a plate was never tested in

A rolled plate is not one material. Rolling stretches its inclusions into flat stringers lying in the plane, so a bar cut along it, one cut across it and one cut through it are three different specimens of one steel — and every mill certificate reports the first.

connections · Lamellar tearing A weld is a force, and it is applied where the weld is. The bow a welded girder leaves the shop with, against how far its welds sit from the section's centroid. A weld cannot contract while the plate holds it, so it yields in tension and what is left when everything is cold is a locked-in force at about the yield stress: 312 kN for the 1.2 kJ/mm of heat drawn, over a shrinkage zone of 439 mm². Applied 210 mm off the centroid that is a moment, and a moment applied along a member is a curvature: the 12 m girder comes out bowed 12.5 mm, which is L/962 against a fabrication tolerance of L/1000. It also comes out 1.2 mm shorter. Welding symmetrically about the centroid puts the resultant on the neutral axis and the bow becomes 0.00 mm — the same heat, the same force, and no moment at all.

The shape that came out of the shop

A weld cools by seven hundred degrees while the plate holds it, so it yields in tension and stays that way. What is left is a locked-in force of three hundred kilonewtons applied where the weld is, and if that is not on the centroid the member leaves the shop bent.

connections · Weld distortion

Named alongside it

The objects these essays reach for when they reach for this one.

Residual stressAnisotropyCurvatureDuctilityEccentricityFabrication toleranceFractureHeat inputImperfectionInclusionsRestraintSecond-order

All concepts