Structural Engineering & Statics
where the load goes
Concept

Triaxial stress — where it appears

A stress state with three non-zero principal components, in which a material's strength is quite different from its uniaxial value. Concrete confined on all sides is far stronger and far more ductile, which is why a small pad on a large block carries three times the cylinder strength.

Named by 2 essays across 2 fields — each of them below, with the objects they name alongside it.

The same concrete, held sideways. Two stress-strain curves for one concrete. The lower is a cylinder test: it peaks at 30 N/mm² near a strain of 0.002 and has nothing left by 0.0035, because it fails by splitting apart sideways. The upper is the same material inside a 12 mm hoop at 100 mm centres, which cannot stop it expanding but can make the expansion stretch steel: the lateral pressure of 2.48 N/mm² — 8% of the strength it is multiplying — takes the peak to 44.4 and the ultimate strain to 0.028. The strength gain is 1.48 times and the strain gain 8.0; the area under the curve, which is the toughness, goes up by 11. It is the third number the confinement is provided for.

Squeezed sideways into a different material

Concrete in a cylinder test fails by splitting apart sideways under a load pushing it down. Put a hoop round it and the splitting has to stretch steel — and a lateral pressure of a twelfth of the strength raises the strength by half and the ultimate strain by eight.

materials · confinement An enhanced strength that is the strength of a tie. Bearing strength as a multiple of the design cylinder strength, against how far the load is allowed to spread, with the bursting tension the spread creates on the same axis. The enhancement is √(A₂/A₁) and it reaches 2.80 for the 250 mm pad on a 700 mm block drawn — 47.6 N/mm² against a design strength of 17.0. There is no material property in that statement beyond the one being enhanced, and the reason is on the second curve: a load that spreads does so along inclined struts, a pair of inclined struts has a horizontal component, and that component is 16.1% of the load. It has to be tied. 1099 mm² of steel is what the enhancement actually is, and the cap of three is not a property of concrete — it is the angle past which nobody believes the strut.

Three times as strong under a smaller pad

Press a small plate onto a large block of concrete and it will carry three times the stress a cylinder of the same concrete fails at. The enhancement is a ratio of areas with no material property in it, which should be a warning: what has actually been measured is not the concrete's strength but the strength of a tie holding it together.

internal-forces · bearing stress

Named alongside it

The objects these essays reach for when they reach for this one.

ConfinementAnchorage zoneArchingBearingBearing stressBurstingDiscontinuity regionDuctilityEnergy dissipationFree bodyHoopLateral pressure

All concepts