Structural Engineering & Statics
where the load goes
Concept

Stub column — where it appears

A compression member short enough that its buckling length has almost no influence on its capacity, so it fails at very nearly the squash load of its area. Bearing stiffeners, base plates and test specimens for residual stress are all checked as one, and the point of the idealisation is that it isolates the section's own strength from anything about its length.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

Not where the two loads meet. How much a column loses below the weaker of its two single-mode capacities, against the ratio of its local critical load to its global one. The received claim is that the worst place is where the two coincide; the arithmetic says otherwise. The erosion is largest at a ratio of 0.47 — 23% — sits within a per cent of that for every ratio below about a half, and at exact coincidence is only 2%. What the curve does say is the useful half of the folk claim: once the plates are stocky enough that the local critical load is twice the global one, the interaction is nothing at all, and the section is worth thickening only up to there.

Two ways of buckling at once

A thin-walled column can bow as a whole or ripple in its plates, and each has its own critical load. The received advice is that the worst arrangement is the one where the two are equal. The arithmetic says the opposite — at coincidence the interaction costs two per cent, and the expensive region is where the plates go first.

stability · Mode interaction The stub column a bearing stiffener makes, in plan. A plan through the girder at the bearing. The 8 mm web runs across; the pair of 100 × 12 stiffeners stands off it; and the shaded strip of web either side — 15ε t_w, or 98 mm each way — is the width that buckles with the stiffeners rather than independently of them. Together they are an area of 3962 mm² with a second moment of 9.01·10⁶ mm⁴ about the web's centreline, a radius of gyration of 48 mm over a buckling length of 900 mm — 0.75 of the depth, because the flanges hold the ends. That is a slenderness of 0.25, at which the column curve returns 0.98: the stub column reaches 98 per cent of its squash load, and the section's own strength is very nearly the whole answer.

A column nine hundred millimetres long

The patch-load check asks how much of a web a flange can spread a wheel over, and answers in a plate-buckling reduction that throws seven tenths of it away. A pair of stiffeners does not improve that answer. It replaces the question with a different one, from a different family, with a different failure in it.

stability · Patch loading

Named alongside it

The objects these essays reach for when they reach for this one.

Section classificationSlendernessSquash loadBearing stiffenerCold-formedColumn curveCritical loadDirect strength methodEffective lengthEffective widthEigenvalueGlobal buckling

All concepts