Structural Engineering & Statics
where the load goes
Concept

Equivalent stress — where it appears

A single number combining several stress components, so that one comparison with a yield stress replaces many. For metals it is the von Mises combination of normal and shear stresses, and it is what allows a wall carrying bending, shear and torsion at once to be checked against one material property.

Named by 2 essays across 2 fields — each of them below, with the objects they name alongside it.

One criterion inside the other, touching at six points. The two yield criteria in principal stress space with the third principal stress zero, both normalised by the yield stress. Von Mises is the ellipse — σ₁² − σ₁σ₂ + σ₂² = f_y², which is a circle seen at an angle — and Tresca is the hexagon inscribed in it, touching at the six points where one principal stress is zero or the two are equal. Everywhere else Tresca is the smaller, by up to 15.5 per cent, and the widest gap is at pure shear, where σ₁ = −σ₂ and the two answers are 205 and 178 N/mm². The ratio there is exactly 2/√3, computed rather than quoted, and it is the whole reason a web is checked against f_y over root three.

The shear strength nobody measured

Every web on this site is checked against the yield stress divided by the square root of three, and no test produced that number. It is a consequence of a decision about what makes a metal yield, and the alternative decision gives a different answer by fifteen per cent.

materials · Yield criterion Two webs of one box, carrying different amounts of the same load. The equivalent stress on each web of a 3.0 × 2.0 m box along the half span, under 40 N/mm at an eccentricity of 1500 mm, with the bending stress alone drawn for comparison. The two webs carry the same bending and opposite torsion, so one gets the sum and the other the difference: at the quarter point the loaded web is at 116 N/mm² and the far web at 11, a ratio of 10.9. A check made on the section rather than on the wall reports the average of two numbers that differ by that much.

Three actions on one web

A load applied off the centreline of a box girder is three actions at once, and every textbook decomposes it into them. What the decomposition does not say is that all three land on the same piece of plate — added on one web and subtracted on the other, so the two walls of one section differ by a factor of ten.

sections · Multicell torsion

Named alongside it

The objects these essays reach for when they reach for this one.

Web shearBox girderBredts formulaConfinementDeviatoric stressDiaphragmDistortionDuctilityEccentricityHydrostatic stressInteraction diagramMohr circle

All concepts