Structural Engineering & Statics
where the load goes
Concept

Biaxial stress — where it appears

A state in which a plate carries direct stress in two directions at once, such as a pressurised tube's hoop and axial stresses. Yield and necking then depend on the ratio of the two, so a weld or a soft zone can be weaker or stronger than under the same stress in one direction.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

The confinement that slenderness switches off. The capacity of a concrete-filled tube against slenderness, divided by the plain sum of its two materials. Below about λ̄ = 0.5 the concrete is confined and the section is worth more than its parts — up to 29 per cent for a stub. Above it the bonus is gone, because confinement needs the concrete to dilate, dilation needs strain, and a slender column buckles before it gets there. The column drawn is at λ̄ = 0.42 and has 0.3 per cent of a bonus, which is to say none. What does not switch off is the other half: at d/t = 80 an empty tube buckles locally at 286 N/mm², below its own yield of 355, and the filled one reaches 508 because the wall cannot go inward. That is worth more than the confinement ever was, and it applies at every slenderness.

Each one stops the other failing

A concrete cylinder crushes by splitting outward and a thin steel tube fails by rippling inward. Put one inside the other and each material's failure mode requires a movement the other one prevents, which is a much stronger statement than composite action.

materials · Filled tube What a 60-degree seam leaves of the wall. The combinations of axial stress σa and hoop stress σh that a tube of 6082-T6 (parent ultimate 310 N/mm², softened zone 185) carries, with its seam at 60° to the axis (solid), inside the parent wall's von Mises ellipse (dashed). Where the solid line falls inside the ellipse the seam's zone fails first. axial tension: 60 per cent of the parent; closed pressure: 78 per cent of the parent; hoop alone: 76 per cent of the parent. The seam is weakest, at 60 per cent, along the loadings whose unstretched line lies on it.

The seam that pressure protects

A soft weld zone pulled at 55 degrees to the load gets no help from the metal around it, because 55 degrees is the line a plate under uniaxial tension does not stretch. A spiral-welded tube winds its seam at about that angle. Pressurise the tube and the line that does not stretch moves to the tube's own axis, so the spiral seam is suddenly well protected and the longitudinal seam is the exposed one. The soft zone's weakness belongs to the loading as much as to the weld: a seam is in danger only where the field around it leaves its line unstretched.

materials · Heat-affected zone

Named alongside it

The objects these essays reach for when they reach for this one.

Hoop tensionYield criterionComposite actionConfinementConstraintHeat-affected zoneInteractionLocal bucklingNeckingSlendernessVon misesWelding

All concepts