Structural Engineering & Statics
where the load goes
Concept

Taper — where it appears

A variation of a member's section along its length, usually to put material where the action is largest. For stability it is weighted by the square of the mode's curvature rather than uniformly, so a taper's benefit depends on where it puts the material relative to where the mode bends.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

A column that has nothing on it but itself. A 30 m column carrying no load except its own weight, with its buckled shape and the axial force that produced it. The force is zero at the top and largest at the base, which is why the answer is not Euler's: the eigenvalue is a load intensity and comes out as q_cr L³/EI = 7.835, a number with no π in it, computed here as the smallest eigenvalue of the same stiffness and geometric-stiffness matrices that give a tip-loaded column its Euler load. It is equivalent to a tip load of 3.18 times as much total weight — a column carries its own weight better than it carries somebody else's, because most of the weight is near the base where the buckle is not. The height limit that follows is a cube root, so a section of radius of gyration 80 mm falls over on its own at 52 m and one of twice that reaches only 82.

Too tall for nothing but itself

Every critical load on this site so far has been applied at the top of a column. A mast carries a load that is zero at the top and largest at the base, the governing equation stops being harmonic, and the answer comes out as a number with no π in it — along with a maximum height that is almost the same for steel, aluminium and wood.

stability · Self-weight buckling The average is not the answer, and it is unsafe. Critical load of a pinned column whose middle third has been given a different stiffness, against the whole-column Euler load, with the two numbers a hand check reaches for beside it. The eigenvalue is taken from K − P·Kg over 24 elements, so nothing here is a formula for a stepped column — it is the same computation the uniform case gets. At a middle third of 0.50 times the rest the true load is 0.612 of Euler's, the arithmetic average says 0.832 and the weakest segment says 0.496. The average is high by 36% and it is high on the unsafe side, because the third of the column it is averaging over is the third where the mode has all its curvature. The weakest-segment answer is safe everywhere and wasteful by about as much.

An average stiffness is not a safe stiffness

Euler's load belongs to a column of one EI. Give the same column two, and the temptation is to average them — which is wrong, and wrong in the unsafe direction by a quarter. Buckling weights stiffness by the square of the curvature of the mode, so the middle of a pinned column decides everything and the ends decide almost nothing.

stability · Stepped column

Named alongside it

The objects these essays reach for when they reach for this one.

BucklingCritical loadEigenvalueGeometric stiffnessSlendernessBuilt-up columnColumnEffective lengthImperfection sensitivityInteractionMastMode shape

All concepts