Structural Engineering & Statics
where the load goes
Concept

Holding-down bolt — where it appears

A bolt cast into a foundation that ties a column's base plate down, carrying tension once the base's resultant leaves the compression the plate can deliver. Under a moment its force is set by the lever arm from that compression, which sits under the column flange rather than at the plate's edge, so it is often twice a rigid-plate estimate.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

A base plate, and when the bolts start working. A 500 × 400 mm plate carrying 600 kN and 90 kN·m, so the resultant sits 150 mm from the centre against a kern of 83.33 mm. The plate is in partial contact: bearing over 300 mm at a peak of 10 N/mm², with the holding-down bolts carrying 0 kN. The plate lifts at 50 kN·m and crushes at 120 kN·m, and the bolts are not needed until 150 kN·m.

Where the structure meets the ground, and when the bolts start working

Push a base plate off its middle third and it lifts off the foundation. The holding-down bolts then carry exactly nothing, and go on carrying nothing until the plate has crushed the concrete underneath it.

connections · Base plate The compression is under the flange, not at the edge of the plate. A 500 × 400 mm base plate, 20 mm thick, under a 260 mm column carrying 300 kN and 120 kN·m, with holding-down bolts 60 mm from the tension edge. A plate this thick can deliver bearing only 43 mm past the compressed flange, so the compression sits under that flange, 124 mm from the column's centre, and the lever arm to the bolts is 314 mm: the bolts carry 264 kN and the flange zone 564 kN. The dashed block is the rigid-plate answer, 54 mm deep at the plate's far edge with its resultant 223 mm out, which needs only 128 kN in the bolts. Both satisfy equilibrium; only one is a plate that can carry the pressure where it is drawn.

The compression that stays under the flange

Put a moment on a base plate and a pressure-block calculation pushes the compression out to the plate's edge, where the lever arm to the holding-down bolts is longest. A plate that is not rigid cannot put it there. The compression stays within a few tens of millimetres of the compressed flange, the lever arm shrinks, and the bolts carry twice what the pressure block said.

connections · Base plate

Named alongside it

The objects these essays reach for when they reach for this one.

Base plateConnectionEccentricityLower-bound theoremBearingBearing stressColumnComponent methodEffective areaFoundationLever armMiddle third

All concepts