Structural Engineering & Statics
where the load goes
Concept

Fire protection — where it appears

Insulation applied to a steel member, as board, spray or intumescent coating, to slow the heat that reaches it in a fire. The thickness needed grows with the section factor, and a protected member heats slowly enough to be endangered by a long fire rather than a hot one, the opposite of a bare member.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

Also named here as heat transfer, specific heat, standard fire — the same set of essays touches all of them, so they are one junction rather than several.

The fire is one curve, and the steel in it is several. Gas temperature and steel temperature against time in a standard fire. The gas curve is the same for every member in the compartment; the three bare steel curves are section factors of 76, 160 and 323 per metre, and they reach 558 °C at 17, 11, 8 minutes — a spread of a factor of two from geometry alone. The fourth curve is the middle section with 15 mm of board on it, which reaches the same temperature at 46 minutes. The kink near 735 °C on the bare curves is not a numerical artefact: steel's specific heat spikes there as its crystal structure changes, and the member spends several minutes absorbing heat at almost constant temperature.

The temperature is a shape

Two members of the same steel in the same compartment, under the same fire and the same load ratio, fail eight minutes apart. Nothing about the material differs and nothing about the fire does. What differs is a perimeter divided by an area, and it is the only number in the whole calculation that a designer chooses.

materials · Fire A room's fire has a peak and an end, and the furnace has neither. Gas temperature in a compartment with 200 MJ/m² of fire load per square metre of its enclosing surface, linings of thermal inertia 1160 J/m²s½K and a medium growth rate, for opening factors of 0.02, 0.04, 0.08, 0.14 m½, against the standard furnace curve, dashed. At 0.02 the fire peaks at 841 °C after 120 minutes and is back at ambient by 435; at 0.04 the fire peaks at 944 °C after 60 minutes and is back at ambient by 171; at 0.08 the fire peaks at 1048 °C after 30 minutes and is back at ambient by 92; at 0.14 the fire peaks at 900 °C after 20 minutes and is back at ambient by 37, having used its fuel before the growth limit, so the fuel rather than the air decided it. A larger opening lets more air in: the fire burns hotter and gets through its fuel sooner. The furnace curve is still rising when every one of them is out.

The fire that goes out

The furnace curve rises for ever. A room's fire has a peak and an end, set by its window, its walls and its fuel, and a bigger window makes it hotter and shorter — which is worse for bare steel and better for protected steel. The protected member is hottest half an hour after the fire has started to die.

materials · Fire

Named alongside it

The objects these essays reach for when they reach for this one.

Critical temperatureFireHeat transferLimit stateLoad ratioSection factorSpecific heatStandard fireEmissivitySection shapeServiceability

All concepts