Structural Engineering & Statics
where the load goes
Concept

Mode interaction — where it appears

What happens when two buckling modes have the same critical load, so that neither governs alone. The interaction erodes the capacity by more than either mode's own imperfection sensitivity, and an optimisation against two failure modes arrives at it by construction, because the maximum of a lower envelope is at a crossing.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

Not where the two loads meet. How much a column loses below the weaker of its two single-mode capacities, against the ratio of its local critical load to its global one. The received claim is that the worst place is where the two coincide; the arithmetic says otherwise. The erosion is largest at a ratio of 0.47 — 23% — sits within a per cent of that for every ratio below about a half, and at exact coincidence is only 2%. What the curve does say is the useful half of the folk claim: once the plates are stocky enough that the local critical load is twice the global one, the interaction is nothing at all, and the section is worth thickening only up to there.

Two ways of buckling at once

A thin-walled column can bow as a whole or ripple in its plates, and each has its own critical load. The received advice is that the worst arrangement is the one where the two are equal. The arithmetic says the opposite — at coincidence the interaction costs two per cent, and the expensive region is where the plates go first.

stability · Mode interaction The best design is where two failures arrive together. A fixed area of steel rolled into tubes of every proportion, with the three things that can end each one. Euler's load goes as r² because I = A r²/2; the local buckling stress goes as 1/r² because the wall thins as the tube grows; squashing does not care. The capacity is the lowest of the three, so it has a maximum — and the maximum is exactly where the two buckling curves cross, at r/t = 129 and 2364 kN, which the closed form r*, the fourth root of αAL² over π³β√3, reproduces to 0.52 per cent. That is the general result and it is not about tubes: the optimum of a minimum of a rising and a falling curve is always their intersection, so optimising a design against two failure modes puts both of them at the design point — which is the one configuration imperfections hurt most.

The best design is the most sensitive one

Take a fixed area of steel and roll it into a tube. Euler's load rises with the radius and local buckling falls with it, so the capacity has a maximum — and the maximum is exactly where the two failure modes arrive together, which is the one configuration imperfections hurt most.

stability · Wall optimum

Named alongside it

The objects these essays reach for when they reach for this one.

Critical loadImperfection sensitivityLocal bucklingOptimisationSlendernessCold-formedDirect strength methodEffective widthEigenvalueGlobal bucklingKnockdownPost-buckling

All concepts