Structural Engineering & Statics
where the load goes
Concept

Delamination — where it appears

Separation of a member along an interface it was relying on, driven by the horizontal shear flow rather than by any bending stress. It is a failure at a plane where no stress calculation was made, which is why the check on a built-up member is a flow rather than a stress.

Named by 3 essays across 2 fields — each of them below, with the objects they name alongside it.

Also named here as shear connection — the same set of essays touches all of them, so they are one junction rather than several.

Shear stress across a section. The distribution of shear stress over an I-section, computed as VQ/It by accumulating the first moment of the area above every height. The peak is 0.41 against a mean of 0.19 — a ratio of 2.15 — and it falls at the neutral axis, where the bending stress is zero.

The shear nobody draws

A stack of loose planks slides at its ends when it is loaded. Glue them and the sliding stops — and whatever the glue is now carrying is a stress that no bending calculation contains.

sections · Shear flow Shear stress across a section. The distribution of shear stress over an I-section, computed as VQ/It by accumulating the first moment of the area above every height. The peak is 82.77 against a mean of 38.46 — a ratio of 2.15 — and it falls at the neutral axis, where the bending stress is zero. At the junction between flange and web the flow is 820.0 per unit length, so connectors of 20000 each have to be spaced no further apart than 24 — which is what turns two pieces into one section.

The section made of pieces

Two plates bolted together are twice as strong as one plate. Two plates made to act as one section are eight times as stiff. The difference is entirely in the joint, and the joint has a calculable spacing.

sections · Second moment Two beams, or one beam four times as stiff. Two 200 × 150 planks spanning 4 m under 6 per millimetre. Loose, they have 112.5×10⁶ mm⁴ between them and deflect 16.2 mm, with the two faces at the interface sliding past one another. Bonded, the pair has 450.0×10⁶ — exactly 4 times as much, because doubling a depth cubes — and deflects 4.0 mm at half the extreme-fibre stress. Nothing was added but a restraint on slip. With connectors of stiffness 200 the same beam deflects 5.4 mm, which is 89% of the way from one bound to the other.

Two beams, or one beam four times as stiff

Stack two planks and they bend as two beams whose faces slide past one another. Bond the faces and the pair has one neutral axis, four times the second moment and half the stress. Nothing was added but a restraint on slip.

internal-forces · Composite action

Named alongside it

The objects these essays reach for when they reach for this one.

First moment of areaNeutral axisShear connectionShear flowBuilt-up sectionSecond moment of areaComposite actionI-sectionParallel-axis theoremPlane sectionsShear stressSlip resistance

All concepts