Structural Engineering & Statics
where the load goes
Concept

Arch thrust — where it appears

The horizontal force an arch pushes its abutments apart with, equal to the free bending moment of the same span divided by the rise. It is what distinguishes an arch from a beam, and in the column analogy it is the gradient of a bending stress on the analogous column rather than a separate calculation.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

A fixed arch, and the section it is a drawing of. A parabolic arch of 30.0 m span and 6.0 m rise, fixed at both springings, carrying 20.0 kN/m over the span. On the right the analogous column: the arch's own centreline drawn as a section of width ds/EI, so it is narrow where the arch is stiff. Its area is 32.99 and its elastic centre sits 3.86 m above the springings — 2.14 m below the crown and on no part of the arch at all, which is the point of it. The released moments loaded onto that section give a direct stress of 3054.0 kN·m and a bending stress whose gradient is the horizontal thrust, 375.0 kN.

The centre that hangs in the air

Cross's analogy turns a closed frame into a short column and reads its redundant moments off as that column's stresses. Nothing in it requires the frame to be straight. Run round a fixed arch, the analogous column's centroid is a point two thirds of the way up the rise, on no part of the arch at all, and the bending stress about it is the arch's horizontal thrust. For a parabola under a uniform load the answer it returns is a diagram of nothing, which is exactly right.

deflection · Moment-area An unsymmetric frame, and a section with a product of inertia. A portal of 8.0 m span whose columns are 5.0 m and 3.0 m, carrying 10.0 kN/m on its beam, and beside it the analogous column — the frame's own centreline at a width of 1/EI. The section is no longer symmetric about a vertical line, so it has a product of inertia of −18.4 against Ix = 31.6 and Iy = 168.0, and its principal axes are tilted 7.54° from the horizontal — the dashed pair through the elastic centre. A section with a product of inertia does not bend about the axis it is loaded about, so the thrust and the redundant shear come out of a two-by-two rather than out of two divisions.

The axes that have to be turned first

Make one column of a portal shorter than the other and the analogous column stops being symmetric about a vertical line. It acquires a product of inertia, its principal axes tilt seven and a half degrees, and the thrust and the redundant shear stop being two separate divisions. Using the elastic centre and nothing else — which is what the symmetric construction looks like from outside — reports 17.0 kN·m at the left foot where the frame carries 27.8.

deflection · Moment-area

Named alongside it

The objects these essays reach for when they reach for this one.

Column analogyElastic centreFlexural rigidityIndeterminacySecond momentFunicularPrincipal axesProduct of inertiaThrust line

All concepts