Structural Engineering & Statics
where the load goes
Series

Tapered member — the series

2 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. Two curves climbing together, and the one that catches up first. A 6 m member tapering from 200 to 600 mm, with the moment it carries and the moment it can carry drawn on the same scale below it. The demand rises linearly and the capacity as the square of the depth, so the gap between them closes and then opens again. It is narrowest at 3.00 m from the free end, where the member is 400 mm deep and 79% used, against 70% at the root where the moment is largest.

    The section that changes along the span

    A prismatic beam is checked where the moment is largest, and everyone knows where that is. A tapered one is not, because the capacity is moving too — and for a cantilever with a load at its tip the governing station is exactly where the depth has doubled, with no length, no load and no material in the answer.

    part 1 · sections
  2. The worst section of a haunched rafter is inside the haunch. Utilisation along a 15.3 m portal rafter carrying 8 kN/m, with an eaves moment of 500 kNm and an apex moment of 150, haunched over 3 m from 906 mm deep down to the rafter's own 453. The moment is largest at the eaves and the depth is largest there too, so the eaves is at 0.42; the apex is at 0.31. The peak is 0.46 at 2.98 m — the haunch tip, where the section has just become the bare rafter and the moment is still 226 kNm. The dashed curve is the same rafter with no haunch, which reaches 1.02 and does not pass.

    The section that governs is inside the haunch

    A tapered cantilever has its worst section somewhere along it because the moment grows linearly and the modulus quadratically. A haunched rafter has the same competition with a step in it, and the step is where the check lands — at neither end of the member, at a station no formula names.

    part 2 · sections

All series