Structural Engineering & Statics
where the load goes
Concept

Boundary layer — where it appears

The region near an edge or a discontinuity over which a structure's local disturbance dies out, and the length that region has. It is fixed by the governing equation rather than by the disturbance, so a shell forgets a held edge in about three times 0.78 times the square root of radius times thickness however hard it was held.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

Also named here as dome — the same set of essays touches all of them, so they are one junction rather than several.

The free body that makes a hoop force a pressure times a radius. Half a ring cut along a diameter, with the pressure drawn normal to the wall wherever the wall is. Vertical equilibrium of the half ring is the whole derivation: the pressure acts over the projected width 2R whatever the shape of the arc, the two cut faces carry N each, so N = pR — 300 kN per metre here at 1 MPa on a 0.3 m radius. The result contains no wall thickness, no second moment, and no length along the pipe, which is why a hoop force is the one internal force in this collection that arrives with no lever arm attached to it. The stress does contain the thickness — 25 MPa at 12 mm — but the force does not, and a thicker wall carries exactly the same force at a lower stress.

The force that is only a radius

Every internal force in this collection arrives with a lever arm attached. A hoop force does not. Cut a cylinder along a diameter and the free body settles it in one line — pressure times radius, with no thickness, no second moment and no length in it — which is why a tank wall is thin and why its worst hoop force is not at the bottom.

internal-forces · hoop tension The edge, and the length over which it is forgotten. A cylinder of radius 4.00 m and wall 12 mm under 0.6 N/mm² of internal pressure, held at its base. Away from the base the wall carries the pressure as pure hoop tension and bends nowhere, which is why a pressure vessel is a cylinder. At the base the hoop force is zero, because the wall cannot grow there, and the difference is made up by a boundary layer of bending that dies out inward. The length it dies out over is 1/β = 170 mm — 0.778√(Rt), a geometric mean of the radius and the thickness — and the moment is under a twentieth of its edge value by 3.07 of them. Nothing in that length is the load. The base moment is p/2β², and the bending stress it produces is 1.82 times the membrane hoop stress the whole design is about, at every pressure, every radius and every thickness: the ratio is √3/√(1 − ν²) and contains none of them. The hoop force overshoots by 4.3% at 3.2 lengths in, which is the wall springing back past where it was going.

The length a structure was never given

A disturbance applied at one place dies out over a distance, and the distance is not something anybody chose. A beam forgets a badly applied load over its own depth. A beam on the ground forgets a point load over the fourth root of its stiffness against the soil's. A shell forgets a held edge over the square root of the radius times the thickness — a geometric mean of two lengths three orders of magnitude apart, which is neither of them and is not near either.

internal-forces · edge disturbance

Named alongside it

The objects these essays reach for when they reach for this one.

Bending momentDomeHoop tensionMembrane actionShellCharacteristic lengthCompatibilityCrack controlDecay lengthEdge disturbanceElastic foundationEquilibrium

All concepts