Structural Engineering & Statics
where the load goes
Series

Wind pressure — the series

One essay so far on this idea, and more questions about it than one essay answers.
  1. The wind pushes on one face and pulls on three. A 30 × 20 m building in plan, with the measured pressure coefficient on each face and the arrows drawn in the direction the pressure acts. Only the windward face is pushed; the other three are sucked, and the side faces are sucked hardest of all at c_p = -0.7. The horizontal resultant is 842 kN at a velocity pressure of 0.9 kPa, and the arithmetic of it is the whole point: the leeward suction pulls the building downwind, so it ADDS, supplying 38% of the answer, while the two side faces cancel each other exactly and supply none of it. The coefficients are wind tunnel data; what is computed is the free body they are applied to.

    Most of it is suction

    A wind load is drawn as arrows pressing on the windward face, which is where about three fifths of it comes from. The rest is a pull on the back. The two side faces carry the largest suctions on the building and contribute nothing at all to the answer — and the inside of the building, which nobody draws, decides whether the roof stays on.

    part 1 · equilibrium

All series