Structural Engineering & Statics
where the load goes
Ladder

Wall optimum — the ladder

One essay so far against this idea. A ladder is the distinct arguments that stand against one idea, and this one has room to grow.
  1. The best design is where two failures arrive together. A fixed area of steel rolled into tubes of every proportion, with the three things that can end each one. Euler's load goes as r² because I = A r²/2; the local buckling stress goes as 1/r² because the wall thins as the tube grows; squashing does not care. The capacity is the lowest of the three, so it has a maximum — and the maximum is exactly where the two buckling curves cross, at r/t = 129 and 2364 kN, which the closed form r*, the fourth root of αAL² over π³β√3, reproduces to 0.52 per cent. That is the general result and it is not about tubes: the optimum of a minimum of a rising and a falling curve is always their intersection, so optimising a design against two failure modes puts both of them at the design point — which is the one configuration imperfections hurt most.

    The best design is the most sensitive one

    Take a fixed area of steel and roll it into a tube. Euler's load rises with the radius and local buckling falls with it, so the capacity has a maximum — and the maximum is exactly where the two failure modes arrive together, which is the one configuration imperfections hurt most.

    rung 1 · stability

All ladders