Structural Engineering & Statics
where the load goes
Series

Strain rate — the series

One essay so far on this idea, and more questions about it than one essay answers.
  1. How fast the strain arrived, which a quoted strength does not record. The dynamic increase factor on strength against strain rate, over eight decades. Steel follows Cowper and Symonds' fit, whose constant D = 40.4 s⁻¹ is not an arbitrary parameter — it is the rate at which the material is exactly twice as strong. Concrete in tension follows the model code's two-branch curve and is steeper. The four marked regimes are the argument: a testing machine works at about 10⁻⁴ per second, an earthquake at 5 × 10⁻³, a vehicle impact at a half, a blast at a hundred, and the enhancement across them runs 1.00, 1.08, 1.32, 2.04. So this is a correction that is either negligible or decisive with very little in between, which is why no seismic code carries it and every blast code does. What does not rise is the modulus, which is a lattice property, and the ultimate strength rises only a third as much — so the ultimate-to-yield ratio closes from 1.56 to 1.23 and the material has less warning left in it than it started with.

    The steel that is stronger in a millisecond

    Every strength quoted anywhere in this collection was measured at about a ten-thousandth of a strain per second, because that is what a testing machine does, and nothing on a drawing says so. Load the same steel a million times faster and its yield stress rises by a third.

    part 1 · materials

All series