Structural Engineering & Statics
where the load goes
Series

Splice — the series

One essay so far on this idea, and more questions about it than one essay answers.
  1. The end bolts do the work and the middle ones very nearly nothing. A lap of 10 bolts at 75 mm pitch transferring 800 kN between two plates, with the force each bolt actually carries drawn above it and the flat line a division by the bolt count would have given drawn behind. The end bolts carry 1.16 of their nominal share and the middle ones 0.89. The reason is not in the bolts: at the leading end the first plate is carrying everything and the second nothing, so the two strain at different rates and the slip between them is largest there. In the middle they strain alike, there is almost no slip, and a bolt with no slip across it transfers almost no force. The mean over the worst is 0.861, and the end bolt has to slip 1.16 mm before the rest catch up.

    The joint that has to be as good as the member

    A splice exists because members come in lengths and structures do not. It has to deliver the same force, at the same stiffness, in the same distribution across the section, through a discontinuity — and each of those three requirements is met by a different feature of the detail, with the third one usually left to look after itself.

    part 1 · connections

All series