Structural Engineering & Statics
where the load goes
Series

Joint classification — the series

3 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. What the joint does to the beam. End moment as a fraction of the fixed-end value wL²/12, against the joint's rotational stiffness, for a beam of EI/L = 14000. At the rigid boundary of 112000 kN·m/rad the joint delivers 80% of it and at the pinned boundary 20%. Everything between the two lines is a redistribution nobody chose and every analysis assumed away.

    The redistribution nobody chose

    A beam designed as simply supported, on connections that are not pins, has end moments the analysis never predicted and a mid-span moment smaller than it was sized for. Usually that is safe. It is never intentional, and there is one direction in which it is not safe at all.

    part 1 · connections
  2. Where the span moment and the support moment cross. Span moment and support moment against the joint's stiffness, for a 6 m beam under 30 kN/m. They move in opposite directions because they add to a constant — the simple-span 135 kN·m is fixed by statics and the joint only decides how it is split. They cross at 68 kN·m, where the joint is delivering 75 per cent of the fixed-end moment, and neither the crossing nor the fraction depends on the beam, the span or the load: it is the point where f·wL²/12 equals wL²/8 − f·wL²/12, which is f = 0.75 for every beam there has ever been.

    The joint that was chosen

    A joint's stiffness decides how a beam's moment divides between its span and its supports, and the two add to a constant. So there is a stiffness at which they are equal, the beam is sized by the smaller of two numbers rather than the larger of one, and the design moment is half what a simple connection leaves behind.

    part 2 · connections
  3. The joint yields first and the span takes the rest. The end and span moments of a beam of span 9 m and flexural rigidity 61,700 kN·m², with a plastic moment of 522 kN·m, on joints of rotational stiffness 41,133 kN·m/rad, 6.00 EI/L, and resistance 261 kN·m, as a uniform load rises to collapse. While elastic the joints carry 0.75 of the fixed-end moment. The joints reach their resistance first, at 51.6 kN/m, and from there every further increment of load goes to the span, which reaches 522 kN·m at 77.3 kN/m. The collapse load is 8(Mp + Mj)/L² = 77.3 kN/m, between the 51.6 at which the beam would collapse on pins and the 103.1 it would reach on rigid full-strength ends, and it contains the joint's strength and not its stiffness.

    The joint that has to keep turning

    A beam on partial-strength joints collapses at 8(Mp + Mj)/L² however stiff the joints are. Stiffness decides only which yields first, and a joint that yields first has to go on rotating at full moment until the span catches up. A weak joint on a stiff connection has the most turning to do — more than a rigid full-strength one.

    part 3 · connections

All series