Structural Engineering & Statics
where the load goes
Series

Indirect support — the series

One essay so far on this idea, and more questions about it than one essay answers.
  1. The same beam, the same load, and one of them has to lift it. Two lower-bound models of one beam, differing only in which chord the 600 kN is applied to. The chord forces are identical in both — the moment diagram does not know where the load arrived — and so are the struts. What is not identical is the vertical at the load: nothing in the top-loaded model, and the whole 600 kN in the hung one, because a bottom-chord panel point touches no strut and the load has nowhere to go but up. That tie is 1200 mm² of steel against the 96 mm² the shear calculation asks for over the same length — a factor of 12.5, in the same place, and additional to it.

    The load that has to be lifted

    Every shear calculation on this site assumes the load arrives on the top of the beam and walks down a diagonal to the support. Hang the same load from the soffit and the diagonal cannot start — the load has to be carried up to the compression zone first, by a tie no sectional calculation contains.

    part 1 · internal-forces

All series