Structural Engineering & Statics
where the load goes
Series

Gridshell — the series

One essay so far on this idea, and more questions about it than one essay answers.
  1. Four ways to make a cell resist being racked, and one that is not one. One cell of a grid shell under the membrane shear it has to carry, by the four mechanisms available for carrying it, with the racking each produces over a 30 m span under 1.2 kN/m² of asymmetric load. A serviceability limit of span/250 is 120 mm. Four pin-jointed bars in a quadrilateral have no in-plane shear stiffness whatever — the cell folds, and the answer is not a large deflection but a mechanism. Rigid nodes carry the shear by bending the members over a cell, which smears to 12EI/s³ and comes to 0.35% of what a continuous sheet of the same stretching stiffness gives: 1205 mm, ten times the limit. One diagonal per cell, or a third member direction, carries it axially instead and lands within a factor of two of the sheet. That is the whole difference between a grid shell and a row of arches.

    A shell only if the grid takes shear

    A curved surface carries load in its own plane at a fraction of the material a flat one needs, and every gridshell ever built is an attempt to buy that with members instead of with a surface. The attempt succeeds or fails on one property nobody draws — whether four bars meeting at a corner can resist being racked — and a pinned quadrilateral grid cannot resist it at all.

    part 1 · structures

All series