Structural Engineering & Statics
where the load goes
Ladder

Buckling restrained — the ladder

One essay so far against this idea. A ladder is the distinct arguments that stand against one idea, and this one has room to grow.
  1. The loop a brace has when it cannot buckle. Force against axial deformation for two braces with the same core area, cycled six times at a storey drift of 2 per cent. An ordinary brace yields at 900 kN in tension and buckles at 482 in compression — 54 per cent of it — and the buckled shape leaves a plastic hinge that does not straighten, so the compression side loses capacity every cycle and is at 12 per cent of its first value by the last. A restrained brace has a casing that carries no axial force at all and only holds the core straight, which decouples axial capacity from flexural stiffness — the coupling that makes a strut weaker than a tie — so it yields at the same force both ways and hardens instead. The energy dissipated is 2.07 times as much over the six cycles, and the casing has to satisfy one inequality: π²EI/L² above the fully hardened core force, 2.56 here, which is a buckling check on a member carrying nothing.

    The brace that yields both ways

    An ordinary diagonal yields in tension at its full strength and buckles in compression at half of it, and the buckle leaves a hinge that does not straighten. Stop it buckling with a sleeve that carries no load at all and the loop becomes symmetric.

    rung 1 · dynamics

All ladders