Structural Engineering & Statics
where the load goes
Ladder

Available sections — the ladder

One essay so far against this idea. A ladder is the distinct arguments that stand against one idea, and this one has room to grow.
  1. The answer is continuous and the catalogue is not. Capacity bought against capacity required, over a real rolled series. The straight line is what a continuous section would give — exactly the moment asked for, and nothing can be bought on it. The staircase is what a catalogue gives: each tread is one section, each riser is the step to the next, and the vertical gap between the two is steel that is paid for and does nothing. The steps in this series run from 23% to 59% in plastic modulus, so the average waste is 15.0% and the worst is 46% — just above a riser, where the section below has been missed by a kilonewton-metre. The 1200 kNm marked buys a 686×254×125 at 1418 kNm, which is 85% utilised. Two things follow that a continuous treatment cannot see: the sensitivity of a design to an assumption is zero over most of a tread and enormous at a riser, and an optimisation that returns three significant figures is answering a question with twelve answers in it.

    The answer is continuous and the catalogue is not

    Every optimisation in this subject returns a number with three significant figures in it, and nothing with three significant figures can be bought. What can be bought is a rolled series whose steps are a quarter to a half apart, so the member that goes on the drawing is on average a tenth stronger than the one that was calculated and can be a third stronger for no reason at all.

    rung 1 · sections

All ladders