Structural Engineering & Statics
where the load goes
Concept

Lateral pile — where it appears

A pile loaded sideways at its head, carried by bending against the ground's resistance along its length. Its behaviour is set by a characteristic length from its stiffness and the soil's: a long pile bends and uses only the top few of those lengths, a short one rotates as a whole.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

Most of a long pile is doing nothing. Head deflection against embedded length, both measured in the pile's own characteristic length T = 14.67 m. A pile shorter than about two T is a lever with nothing holding its foot and deflects several times as much; past four T the curve is flat to within a per cent, because the ground below that depth is never asked for anything. A lateral check is a check on the top four T of a pile, however deep it goes for its axial load — and adding length to fix a lateral deflection is the one remedy that does not work.

The pile that is too short to bend

A laterally loaded pile is long or short in its own characteristic length, and the two are different structures. The slender pile bends and the ground below four characteristic lengths never hears about it; the monopile is two lengths deep, rotates about a point, and every tabulated coefficient written for the first case is wrong for the second.

internal-forces · Lateral pile A soft layer over stiff ground, and a moment neither has. The bending moment down a 20 m pile of bending stiffness 120 MN·m² with a free head, pushed sideways by 150 kN (its characteristic length in ground at 5.00 MN/m³ being 1.89 m), in three grounds: all of it at 5.00 MN/m³; all of it at 0.50 MN/m³; and soft ground 2.0 characteristic lengths (3.8 m) thick over the other (dotted: the interface). The largest moments are 219 kN·m, 346 kN·m and 427 kN·m; the head deflections 20.4 mm, 81.4 mm and 61.6 mm. The layered ground gives a larger moment than either ground on its own: the pile bends as a pile in the soft layer would, and then meets ground that holds it.

The layer a pile feels

A pile pushed sideways in uniform ground has one characteristic length, the fifth root of its stiffness over the ground's, and every answer is a multiple of it. Put a soft layer over stiff ground and that length stops existing. The head feels the top of the ground in proportion to the square of its own deflection, so an average weighted that way gets the head deflection within eight per cent. It gets the moment a quarter too low: with soft ground two characteristic lengths thick over stiff, the pile bends harder than it would in either ground alone, and the peak sits where the stiff ground takes hold.

internal-forces · Lateral pile

Named alongside it

The objects these essays reach for when they reach for this one.

Bending momentCharacteristic lengthElastic foundationSubgrade modulusDeflectionDowndragFree bodyLayered groundPile groupRayleigh methodScaleSoil reaction

All concepts